Replacing The Waste Toner Bottle And Charger - Ricoh AP305 Operating Instructions Manual

Troubleshooting
B Remove the ozone filter from
inside the ventilator hole cov-
er.
C Install a new ozone filter on
the ventilator hole cover.
D Replace the
cover onto the printer.
D
Replace the ozone filters inside
the printer. (There are two filters.)
A Open the front cover by push-
6
ing the front cover release but-
ton.
B Grasping the ozone filter by its
tab, remove it from the printer.
92
TFWX070E
ventilator hole
TFWX080E
TFWX310E
C Insert a new ozone filter into
the printer.
Slide the filter into the stopper.
Two small thin plastic tabs of
the top of the filter should pop
into place.
D Close the front cover.
Make sure that the front cover
close properly.
E
Turn on the printer's power
switch.
Note
After replace the fuser oil bottle,
it takes a few minutes until the
message clears.
Replacing the Waste Toner
Bottle and Charger
You should replace waste toner bottle
and charger whenever the following
messages appear on the panel dis-
play.
IPDL-C
Waste T Full
Waste Toner is
Full
TFWX320E