Table of Contents
Advertisement
2
Installation
Verify printer operation
●
Install the hardware
●
Verify print server operation
●
Configure the print server using the HP Embedded Web Server
●
Verify printer operation
To verify that your printer/MFP is working properly, print a configuration page. The configuration page
displays the operating status of the printer/MFP.
The steps to print a configuration page can vary with the printer/MFP model. For most printers/MFPs
with a control panel, a menu map is provided to navigate the control panel menus. To print a
configuration page, use the menu map or see your printer/MFP documentation for specific instructions.
NOTE:
The name of the printer configuration page might also vary by printer type.
Install the hardware
CAUTION:
damaged by static electricity through electrostatic discharge (ESD). To prevent ESD
damage, maintain frequent contact with any bare sheet metal surface on the printer. A grounding wrist
strap (or similar device) is useful for this purpose. Avoid touching electronic components or circuit
paths.
1.
Upgrade the firmware on your printer/MFP. (See the printer/MFP's setup or user guide for
firmware upgrade instructions.)
2.
After the firmware is upgraded, plug the USB connector on the HP Jetdirect 2700w Print Server
into the printer/MFP's USB connector on the back of the device. Tighten the thumb screws and
ensure that the print server is held securely in place.
NOTE:
are compatible with the HP Jetdirect 2700w Print Server.
ENWW
HP Jetdirect print servers contain electronic components that can be
Only those printers/MFPs listed in the section
What you need for installation on page 1
Verify printer operation
3
Advertisement
Table of Contents
