Advertisement
Stealth installation
Because the device displays the threat and gives a voice signal in the
selected language at the same time, it may be installed into hidden
compartments. There are many places where it can be hidden, for
example, in the glove-box, in the car's center console, into the com-
partment of the armrest, or even below the dashboard. After locating
the given spot, follow the steps of the "Mounting to dashboard"
section.
In case of a stealth installation, a GPS receiver is also necessary to
ensure the connection between the GPS Detector and the satellites.
For the best efficiency, the receivers should be placed to the lower
part of the windscreen. If the windscreen is metalized, the receivers
should be installed into the front bumpers.
d) Setting the device up
Connect the device to the vehicle's cigarette lighter socket (DC 12-24 V)
via the cigarette lighter power cable. If this socket is connected to a
constant current, the Detector will function when the car is not mov-
ing. However, in this case, the device will drain the battery in time,
therefore, after use, you should turn the equipment off. If the socket
is connected to the ignition circuit, the Detector will turn off when the
ignition ceases, therefore it will not drain the battery
The additional radar module can be connected into the RADAR
socket. With this module, the device can detect fixed- and mobile
radar-based speed traps at the same time.
5
Advertisement
