Advertisement
3. ACTIVATING THE LASER MODULE
After installing a compatible external laser module (based on the
instructions of that given equipment's user manual), connect one end
of the communication cable into the COM socket of the GPS detector,
then connect the other end into the central unit of the laser module.
If the laser module has been installed correctly and it is connected
to a power supply, the cigar lighter power cable of the GPS detector
will not be needed, as it will be powered by the laser module itself.
For the best efficiency of some functions (SLM – Smart Laser Mute,
Speeding alarm), remove the speaker of the laser module (if there
is one), because the audio-visual warnings will come from the GPS
detector itself.
The LED indicators of the laser module will not be needed, as the LED
of the communication cable itself will show the warnings.
After successfully connecting devices together and into a power sup-
ply, the "Monitoring external laser module" function must be enabled
in the menu system of the detector.
With the "Monitoring external laser module" function enabled, the
GPS detector will give a "No connection with the external module"
warning in the following cases: the connection between the devices
is not installed correctly; the communication cable was disconnected
from one of the devices; the laser module is offline; the laser module
malfunctioning or crashed.
If the devices are correctly connected, after initialization the GPS
detector will state the chosen state of the laser module (active mode,
passive mode, parking assist mode)
24
Advertisement
