Ricoh 70 User Manual page 98

Message
Invalid Password
Invalid Time Server Address
Invalid Value
LED Eraser Not Set
Set Erase Lamp E080
Lifting Tray Name
Loading Fail Network
Loading Network
Low on Front Staples
Low on Rear Staples
Low Toner - Recovery
E09A
MBT
Load xx E090
Network Load Failed
Open Stacker Full
Out of Front Staples
Load Staples
Out of Rear Staples
Load Staples
Paper in Duplex Path
Remove Paper E05C
Paper in Fin Holding Path
Remove Paper
Paper in Fin Sheet Path
Remove Paper
Paper in Finisher
Remove Paper E064
Paper in Finisher
Remove Paper E065
Paper in Finisher
Remove Paper E066
Paper in Finisher
Remove Paper E067
Paper in Finisher
Remove Paper E068
Paper in Fuser
Remove Paper E070
Paper in Input Station
Remove Paper E050
Paper in Input Station
Remove Paper E051
5-10 Troubleshooting
Description
A valid password is required to access
this area of the OCP.
Incorrect value in time server IP
address field.
Incorrect value entered.
The LED eraser is not set.
The specified tray is moving into the
feed position.
Status message.
Status message.
Status message.
Status message.
In process of supplying the toner.
The wrong paper size is loaded in the
multi-bypass tray.
Network connection error.
The output tray is full.
The front stapler unit of the Finisher is
out of staples.
The rear stapler unit of the Finisher is
out of staples.
Paper jam on return path 1.
Paper jam in holding path.
Paper jam in sheet path.
Paper jam in entrance path of the
Finisher.
Paper jam in exit path of the Finisher.
Paper jam in bypass of the Finisher.
Paper jam in staple tray of the Finisher. Remove the jammed paper.
Paper jam in exit path of the Finisher
sub tray.
Paper jam in fuser unit.
Paper jam on IS path 1.
Paper jam on IS path 2.
OG L
Corrective Action
Retry password. If incorrect, contact
your System Administrator.
Check the time server IP address via
the Web Utilities.
Re-enter value.
Contact your authorized Service
Technician.
Status message. Wait for the printer to
return to a Ready state.
Wait for the printer to return to a Ready
state.
Wait for the printer to return to a Ready
state.
Have replacement staples available.
Have replacement staples available.
Wait for the printer to return to a Ready
state.
Load the MBT with the requested
paper size.
Check the Ethernet cable of the NIC.
Remove the paper from the tray.
Replace the front staple cartridge.
Replace the rear staple cartridge.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
0 1