Setting Up As A Remote Printer (Netware 3.X) - Ricoh 220-240 V Software Manual

Setting Up as a Remote Printer (NetWare 3.x)

Follow the procedure below to use the printer as a remote printer under Net-
Ware 3.x.
Setting up using PCONSOLE
A
Enter "PCONSOLE" from the command prompt.
F:> PCONSOLE
B
Create a print queue.
When using the existing print queue, go to the procedure for creating a printer.
C
From the [Available Options] menu, select [Print Queue Information], and then
press the {Enter} key.
D
Press {Insert} key, and then enter a print queue name.
E
Press {Esc} key to return to the [Available Options] menu.
F
Set up the network connection to a printer.
G
On the [Available Options] menu, click [Print Server Information], and then press
the {Enter} key.
H
To create a new print server, press the {Insert} key, and then enter a print
server name.
For a currently defined print server, select a print server in the [Print Server] list.
Use the same printer name specified using NIB Setup Tool.
I
From the [Print Server Information] menu, select [Print Server Configuration].
J
From the [Print Server Configuration] menu, select [Printer Configuration].
K
Select the printer indicated as [Not Installed].
Use the same printer number specified as the remote printer number using
NIB Setup Tool.
L
To change the printer name, enter a new name.
A name "Printer x" is assigned to the printer. The "x" stands for the number
of the selected printer.
M
As type, select [Remote Parallel, LPT1].
The IRQ, Buffer size, Starting form, and Queue service mode are automatical-
ly configured.
N
Press the {Esc} key, and then click [Yes] on the confirmation message.
O
Press the {Esc} key to return to [Print Server Configuration Menu].
Using NetWare
7
283