Operating Instructions; Machine Set-Up - Bosch TRANSFLOW j-45096 Operation Manual

Operating Instructions

Machine Set-Up

1. Drain the waste oil vessel. (Refer to the Waste
Oil Removal procedure on page 15.) If the
waste oil vessel is empty, proceed to step 2.
2. Verify that the main power switch is in the
OFF position.
3. Place the main function switch in the IDLE
position. See Figure 1.
IDLE
FLUID 00 QTS @ 075F
Figure 1
4. Connect the TransFlow machine to the ve-
hicle 12V DC power source by connecting
the red battery clip to the positive (+) battery
post on the vehicle and connect the negative
lead to a known good chassis ground. See
Figure 2.
Figure 2
5. Turn the main power switch to the ON posi-
tion.
6. Fill the supply tank with Dexron VI
equivalent, through the fill port.
See Figure 3.
Caution: Do not overfill the supply vessel.
Damage to the unit may result. To verify the fluid
level, view the LCD screen display while filling
the unit to ensure that the fluid level does not
exceed 32 US quarts. See Figure 4.
7. Reinstall and tighten the fill cap.
8. Connect a shop air supply hose to the
quick-disconnect on the rear panel marked
SUPPLY AIR. See Figure 5.
TRANSFLOW Transmission Cooling System Service Tool J-45096
® ATF, or
Figure 3
IDLE
FLUID 20 QTS @ 075F
Figure 4
Figure 5
11