Kenwood DDX395 Instruction Manual page 37

Bluetooth® Bluetooth®
Pairing a Bluetooth device using a PIN code (for
Bluetooth 2.0)
1
Display the <PIN Code Set> screen.
On the Home screen, touch as follows:
Then, on the <Setup> screen, touch as follows:
[System] <Bluetooth Setup> : [Enter]
On the <Bluetooth Setup> screen, touch as
follows:
<PIN Code> : [0000]
2
Change the PIN code.
If you wish to skip changing the PIN code, go to
step 3.
PIN Code Set
0000
1 2 3
4 5 6
7 8 9
0 Enter Clear
• To delete the last entry, touch [Clear].
• To delete the PIN code, touch and hold [Clear].
3
Search for the unit ("DDX3eX"/"DDX3"/
"DDX4") from your Bluetooth device.
4
Select the unit ("DDX3eX"/"DDX3"/
"DDX4") on your Bluetooth device.
• If a PIN code is required, enter "0000" (initial) or
new PIN code you have entered in step 2.
• When pairing is completed, the device is
registered on the <Paired Device List> screen.
Note
• The PIN code is initially set to "0000".
• The maximum number of digits in the PIN code is 15.
Connecting/disconnecting a registered
Bluetooth device
1
Display the <Paired Device List> screen.
On the Home screen, touch as follows:
Then, on the <Setup> screen, touch as follows:
[System] <Bluetooth Setup> : [Enter]
On the <Bluetooth Setup> screen, touch as
follows:
<Paired Device List> : [Enter]
2
1
Select the device ( ) you want to connect,
then select [Connection] (
Paired Device List
Device Name 1
Device Name 2
Device Name 3 OK
Device Name 4 Connection
Device Name 5 Remove
3
Select the device (
return to the <Paired Device List> (
BT Connection Settings
Device Name
Connected
Connect Ready
Select [ON] (to connect) or [OFF] (to disconnect).
: Mobile phone
: Audio device
4
Connect the selected device.
Paired Device List
• The status is shown as follows:
– <Connecting>: Connection is in progress.
2
).
– <Connected>: A connection has been established.
– <Connect Ready>: A connection can be
established.
– <Disconnecting>: Disconnection is in progress.
– <Disconnected>: No connection is established.
• When a Bluetooth mobile phone is connected, the
signal strength and battery level are displayed when
the information is acquired from the device.
1
) to connect, then
ON OFF
ON OFF
Device Name 1
Device Name 2
Device Name 3 OK
Device Name 4 Connection
Device Name 5 Remove
ENGLISH
2
).
35