Installation Instructions - Keyspan Mini Port Replicator User Manual

Keyspan:Mini Port Replicator for Windows-v3.2 User Manual

3.1 - Installation Instructions

Installing the Mini Port Replicator Software for Windows
Operating Systems
Note: These instructions apply to installing the Keyspan Mini Port
Replicator on Windows. If you are installing this software on other
platforms, please read the Keyspan Mini Port Replicator User
Manual for that platform.
Step 1
-
Insert the Keyspan Serial Adapter CD-ROM
Turn your computer ON. When your computer starts up, place the Keyspan Mini Port Replicator
CD into the CD-ROM drive.
This will open the Keyspan Mini Port Replicator CD browser (Note: you can manually start the
CD browser by locating and running the "
Step 2
-
Run the Keyspan USB Serial Software for Windows Installer
If the Keyspan Adapter is connected to your computer, disconnect it now.
Once the Keyspan CD browser has opened, click on the "Install Software" selection and then
click on the "Install Keyspan Mini Port Replicator Software" selection. This will start the
software installer.
Follow the instructions on-screen to complete the installation.
Step 3
-
Software Installation Complete!
Now that you have installed the Keyspan Mini Port Replicator software, you are ready to install the
Keyspan Mini Port Replicator hardware. Please proceed to the installing the Keyspan Mini Port
Replicator Hardware instructions.
(continued on next page...)
This User Manual applies to the Keyspan Mini Port Replicator Software for Windows.
" program on the CD-ROM).
Launch.exe
(rev 02jun19JA)
Page 5