Mounting The Inverter; Figure 2-2, Approved Mounting Positions - Magnum CSW1012 Owner's Manual

2.0 Installation
2.2.2

Mounting the Inverter

Review the information in this section before mounting the inverter.
Orientating the Inverter
When mounted indoors, the CSW1012 inverter can be mounted on/underneath
a horizontal surface (shelf or table) or on a vertical surface (wall or bulkhead)
with the DC terminals facing left, right, or up—do not mount with the DC
terminals facing downward (see Figure 2-2). When mounted in an RV, mount
flat on a horizontal surface only.
Securing the Inverter
After determining your mounting position, use the base of the inverter's
chassis as a template to mark your mounting screw locations (or, refer to the
dimensions in Figure 2-3). Remove the inverter and drill pilot holes into the
mounting surface. Secure the inverter to the surface using the appropriate
corrosion-resistant hardware (sized #10 – not supplied). If this unit is used
in a mobile application, you may want to place flexible washers or bushings
between the mounting surface and the inverter's mounting flanges to reduce
vibration.
For Indoor Use:
For RV Installation:

Figure 2-2, Approved Mounting Positions

6
Mount flat on a
horizontal surface only
© 2013 Magnum Energy, Inc.
DO NOT mount with
DC terminals facing downward