Polaris Ranger 1000 Diesel Owner's Manual page 86

MAINTENANCE
Fuel Filter/Water Separator
The fuel filter/water separator is located under the
seat on the right side of the vehicle, between the
engine and fuel tank.
Inspect the separator daily for leaks. Drain water
and replace the separator at the intervals outlined in
the Periodic Maintenance Chart beginning on page
65. Service the separator more frequently if the
vehicle is operated with inferior fuel.
CAUTION! Both fuel and water will drain from the
separator during the following procedure. Use caution
and observe all fuel safety precautions when handling
fuel.
1. Remove the seat. Disconnect the battery.
2. Place an appropriate container under the fuel filter
drain to catch fluids (water and fuel).
3. Slightly loosen the bleed screw to relieve fuel
pressure in the filter. Do not tighten the screw at
this time.
4. Reach under the fuel filter and slightly loosen the
drain valve until the fluids drain from the drain
hole. Do not completely unscrew the drain valve.
5. When fluids stop draining from the valve, tighten
the valve firmly (by hand only).
6. Reconnect the battery.
7. Turn the ignition key on to engage the fuel pump.
Leave the key on only until fuel begins to spit
from the bleed screw, then tighten the screw.
8. Clean up any spilled fuel and soiled shop towels
properly.
9. Cycle the key switch from OFF to ON six times,
waiting three seconds at each "ON" cycle to
allow the fuel pump to cycle.
10. Start the engine and check for fuel leaks.
11. Reinstall the seat.
84
Drain Valve Bleed Screw
Tighten
Loosen
Drain Hole
(viewed from bottom)