Wheel Removal; Wheel Installation - Polaris Ranger 1000 Diesel Owner's Manual

MAINTENANCE
Tires

Wheel Removal

1. Position the vehicle on a level surface.
2. Place the transmission in PARK. Stop the engine.
3. Loosen the wheel nuts slightly.
4. Elevate the side of the vehicle by placing a suitable stand under the frame.
5. Remove the wheel nuts and washers. Remove the wheel.

Wheel Installation

1. Place the transmission in PARK.
2. Place the wheel in the correct position on the
wheel hub. Be sure the valve stem is toward
the outside and rotation arrows on the tire
point toward forward rotation.
WARNING! Improperly installed wheels can
adversely affect tire wear and vehicle handling, which
can result in serious injury or death. Always ensure
that all nuts are torqued to specification. Do not
service axle nuts that have a cotter pin installed. Your
POLARIS dealer can assist.
3. Attach the wheel nuts and washers and
finger tighten.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts to specification. See page 89.
Power Steering Unit
If your model is equipped with power steering,
frequently clean the areas around and on the power
steering unit to allow proper cooling. Clean these
areas thoroughly.
90
Clean Often