Starting The Engine; Stopping The Engine - Polaris Ranger 1000 Diesel Owner's Manual

Starting the Engine

NOTICE: NEVER use an engine starting aid such as ether. Engine
damage will result.
Before operating this vehicle in cold weather, review the cold
weather operation information beginning on page 40.
Always wait for the glow plug indicator light to turn off
before cranking the engine.
1. Always start the engine outdoors or in a well-ventilated
area.
2. Sit in the driver's seat and fasten the seat belt. Secure the
cab nets (or doors).
3. Place the transmission in PARK.
4. Apply the brakes. Do not press the throttle pedal while starting the engine.
5. Turn the ignition switch to the ON position and wait for the glow plug indicator light to
turn off.
6. Turn the ignition key past the ON/RUN position to START. Engage the starter for a
maximum of five seconds. Release the key when the engine starts.
7. If the engine does not start within five seconds, release the ignition switch and wait five
seconds. Repeat steps 6 and 7 until the engine starts.
NOTICE: Operating the vehicle immediately after starting could cause engine damage. Allow the
engine to warm up for several minutes before operating the vehicle.

Stopping the Engine

For maximum engine life, allow the engine to idle, without load, for 5 minutes. This will
allow the engine components that operate at high temperatures, such as the exhaust system,
to cool slightly before the engine is shut down.
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
3. Turn the engine off and remove the key to prevent unauthorized use.
4. Slowly release the brake pedal and make sure the transmission is in PARK before exiting
the vehicle.
WARNING! A rolling vehicle can cause serious injury. Always place the transmission in PARK when
stopping the engine.
Braking
1. Release the throttle pedal completely.
Tip: When the throttle pedal is released completely and the engine speed drops near an idle, the
vehicle has no engine braking.
2. Press on the brake pedal evenly and firmly.
Tip: If the throttle pedal and brake pedal are applied simultaneously, engine power may be limited.
3. Practice starting and stopping (using the brakes) until you're familiar with the controls.
OPERATION
START
HELP
43