Installation - HIKVISION DS-2CE71D0T-PIRL User Manual

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with your

required output to avoid damage.
Make sure the wall is strong enough to withstand three

times the weight of the camera, and the mount.
If the wall is cement, insert expansion screws before

installing the camera. If the wall is wooden, use self-
tapping screw to secure the camera.
If the product does not function properly, contact your

dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Ceiling/Wall Mounting without Junction Box
Steps:
1. Disassemble the camera.
1). Rotate the camera to align the notch to one of the
marks.
2). Pry the mounting base to remove the mounting base
with the camera body with a flat object, e.g., a coin.
Mark
Notch
2. Paste the drill template (supplied) to the place where
you want to install the camera.
3. Drill the screw holes, and the cable hole (optional) in
the ceiling/wall according to the drill template.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable
4. Attach the mounting base to the ceiling/wall, and
secure them with supplied screws
Figure 2-1 Drill Template
Coin