Installation - scandia Supremacy 300 Owner's Manual

INSTALLATION

FOR CONNECTING INTO A STANDARD INSTALLATION
USING SCANDIA DEFAULT FLUE KITS
The following drawing is meant as a guide only. Your wood heater must be installed by a qualified person whose work conforms
with local council regulations, Australian/New Zealand standards (AS/NZS 2918:2001) & manufacturers recommendations.
Scandia wood heaters are independently tested to Australian Standards using a Scandia flue kit, we always recommend using
a Scandia flue kit when installing a Scandia wood fire.
ROOF
Min 25mm from outer
casing to any combustible
material
ANGLE BRACKET
CERAMIC SPACERS
Min 25mm
INNER 6" STAINLESS STEEL FLUE
(CRIMPED END DOWN)
180 FIXED HEAT SHIELD
LOCATION TAG
1. Locate wood fire in it's proposed position according to manufacturers recommendations.
2. Use a plumb bob to mark the ceiling in line with the centre of the flue collar.
3. Check that the outer casing will clear all combustible materials by 25mm. Determine positions of noggins to avoid
cutting, otherwise headers must be installed for strength.
4. Cut a 305mm diameter hole in the ceiling. Directly above cut a hole in the roof to accommodate outer casing.
5. Fix the angle brackets to the joists so that the drop box (first length of located casing) is located in the centre of the hole.
....continued
ANTI DOWN DRAFT COWL
COVER CONE
SECURE COVER CONE TO CASING W/ SCREW
ROOF FLASHING (NOT SUPPLIED IN KIT)
RAFTER
MIDDLE 8" GALVANISED CASING
OUTER 10" GALVANISED CASING
JOIST
CEILING
Min 150mm of drop box must
extend from any combustible
surface including ceiling
CEILING COLLAR FIXED WITH SCREW,
WITH CERAMIC SPACERS BETWEEN
CEILING COLLAR AND THE CEILING
DECORATIVE CASING POSITION, SEAM TO REAR
HEATER FLUE COLLAR
HEATER
5.