Embellished Garment Care - Ioline CrystalPress User Manual

1. Proper adhesion depends on adsorption of the adhesive into
the substrate when used with textiles. Materials with water-
proofing treatments do not work well as they resist absorption.
To test for an incompatible coating, lay a sample flat and
sprinkle water on it. If the water beads up instead of absorbing,
the adhesive on the stones will not work with the material.
2. Pre-heat the garment or accessory in the heat press WITHOUT
the motif for 5-10 seconds. This removes moisture from the
material and improves the bond during adhesive melting.
3. Cut the excess Transfer Sheet away from the motif before ap-
plication. Get the edges close to the motif outlines. This will
reduce marks on the fabric from the unused Transfer Sheet
adhesive.
4. Protect the heat press with a Protective Sheet between the top
and bottom Platens of the press. The most common protective
material is a Teflon® sheet although heavy craft paper (like a
brown paper bag) will work too.
5. Don't remove the Transfer Sheet until the design has cooled.
This takes from 1 to 5 minutes. Test the time to make sure.
6. Protect Synthetic Suede and Fur fabrics after application by peel-
ing off the Transfer Sheet in the direction of the nap.
7. If crystals do not set properly during the first process attempt,
re-apply heat with adjusted pressure and/or temperature.
8. The adhesive will continue to harden for 24 hours after applica-
tion so do not subject the product to wear or washing for one
day after production.
9. It is possible to bond crystals to materials other than textiles.
Metal, glass, wood and paper are possible. Testing is critical to
determine correct process steps and product life.

Embellished Garment Care

The following guidelines are generic hints specific to an embellished
garment or accessory. It is absolutely necessary to follow the cleaning
instructions of the garment over those listed below.
1. To increase the life of the embellished garment or accessory, do
not wash them for 24 hours after the transfer.
2. Washing Instructions:
a. Water temperature 16° C (60° F)
b. Gentle cycle
c. Mild detergent
d. Turn garment inside out or place in soft wash bag
e. Do not use chlorine bleach
3. Drying Options:
a. Hang dry
b. Turn garment inside out, tumble dry low heat, gentle cycle.
c. Professional dry cleaning is possible with some crystal
brands. Check stone manufacturer specifications first.
Operation
i
Note
Always follow your garment care
instructions before following the
Embellished Garment Care guide-
lines. These always supersede the
generic suggestions in this manual.
29