Product Hardware Features - TRENDnet TPL-331EP User Manual

TRENDnet User's Guide
Expandable
Use up to 8 adapters on a single Powerline network
Easy Installation
TRENDnet adapters auto-connect out of the box
128-bit AES Encryption
Powerline communication is protected with 128-bit AES encryption
Note:
* Maximum of 8 adapters (nodes) recommended for streaming video across your
network.
** 200Mbps is the maximum theoretical Powerline data rate when connected to
another Powerline 200 device. Data throughput may vary by circuit wire conditions.
*** Powerline communication works on a single electrical system. (Usually controlled by
a single distribution panel). Power strip, GFCI outlets, and AFCI circuit breakers may
degrade Powerline network signals.
© Copyright 2018 TRENDnet. All Rights Reserved.

Product Hardware Features

PoE+ Network Port
Reset Button
Button Action
Sync Press for 3 seconds
Reset Press for 10 seconds
Power Save Mode: The Powerline adapter will automatically going into standby mode
to reduce power usage when there is no network traffic for more than 10~20 minutes.
All LEDs are going off. It can be wake up automatically when the network traffic is
coming again. It will take a couple of seconds to wake up and resume back to full speed
of service.
TPL-331EP / TPL-331EP2K
LED Indicators
Sync Button
Function
Begins synchronization session. The POWER LED will
begin to blink for 2 minutes. Press the Sync button on
additional adapters within the time frame to
synchronize to the powerline network.
Resets device to factory defaults settings (All LEDs will
turn off and on again).
Note: Will reset to the factory default private network
name "HomePlug AV".
2