Installation - Caple Orbit OI363 Instruction Manual

Island extractor
Hide thumbs Also See for Orbit OI363:
Table of Contents

Advertisement

INSTALLATION

Before installing the appliance, make sure that none of the parts are damaged in
any way. In case of damaged parts, contact your retailer and do not proceed with
installation.
Read all of the following instructions with care before installing the appliance.
- Use an air outlet pipe of the shortest possible length.
- Limit the number of pipe bends.
- Use a material approved by standards and regulations.
- Avoid any sudden changes in pipe section (recommended constant diameter: 150
mm or equal surface area).
NOTE: For more information on venting, please see our 'Extraction & Ventilation
guide' available on our website www.caple.co.uk.
Attention: at least two people are needed to perform the installation.
Before installing the appliance, in order not to damage the appliance itself, the
metal grease filter should be removed. Such filter can be removed by pushing
the special filter handle toward the back side of the cooker hood and turning it
downwards so to unfasten it from its slot (Fig. 3 A).
Before fixing the hood, place the electric feeding properly into the ornamental pipe
and place a hole for air evacuation in case of a vented mode installation.
Ventilation mode
Place the upper plate (Fig.5.1) on the ceiling. Drill 4 holes, 8 mm each, just next to
the slots. Insert the plastic dowels into the holes (Fig.5.1-A) and screw up the plate
on the ceiling (Fig. 5.1-B). Then fasten the lower structure (Fig. 7.2) on the hood by
making its holes and the metric-thread screws welded on the fan support coincide
(Fig. 7.1). Insert the washers and nuts provided (Fig. 7.2-A) and screw with an
appropriate tool.
Connect the drainpipe to the power unit nozzle and fix securely with a hose clamp.
Insert the upper structure (Fig. 7.3) into the lowest one and adjust its height as
required by matching it with the cooking top's minimum height. Tighten the two
structures securely with the screws provided (Fig. 7.3). Insert the two extension
Please keep this instruction manual for future reference
8
Instruction manual Oi363

Advertisement

Table of Contents
loading

Table of Contents