Caple Orbit OI363 Instruction Manual

Caple Orbit OI363 Instruction Manual

Island extractor
Hide thumbs Also See for Orbit OI363:

Advertisement

Quick Links

Orbit island extractor
instruction manual
OI363
Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk

Advertisement

Table of Contents
loading

Summary of Contents for Caple Orbit OI363

  • Page 1 Orbit island extractor instruction manual OI363 Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk...
  • Page 2: Table Of Contents

    CONTENTS WARNINGS ENVIRONMENTAL PROTECTION USES INSTALLATION REMOTE CONTROL OPERATION MODE TIMING MAINTENANCE Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 3: Warnings

    WARNINGS - The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure they do not play with the appliance. - The cooking surface and the inferior part of the cooker hood must be at a minimum distance of 65 cm.
  • Page 4 - Before carrying out any cleaning or maintaining operations, the appliance needs to be removed from the electric grid. If the appliance is not provided with a non- separable flexible cable and plug, or with another device ensuring omnipolar disconnections from the grid, with an opening distance between the contacts of at least 3 mm, then such disconnecting devices must be supplied within the fixed installation.
  • Page 5 - Where a recirculation cooker hood is fitted above a gas hob, please ensure that there is an adequate supply of fresh air into the room in which it is installed. Please seek the advice of a qualified gas fitter (e.g. GasSafe in the UK) if necessary.
  • Page 6: Environmental Protection

    Radio Equipment Directive (RED) 2014/53/EU This Declaration is issued under the sole responsibility of the manufacturer. Hereby, Caple declares that the radio equipment included in the product is in compliance with the RED directive 2014/53/EU. The full text of the EU Declaration of Conformity is available on our website www.caple.co.uk.
  • Page 7: Uses

    USES The appliance is already arranged both for re-circulation and vented installation/ performance. - In Recirculation mode (Fig.1), the air and fumes conveyed by the appliance are cleaned both by a grease filter and by an active charcoal filter, and put again into circulation through the side grids of the chimney.
  • Page 8: Installation

    NOTE: For more information on venting, please see our ‘Extraction & Ventilation guide’ available on our website www.caple.co.uk. Attention: at least two people are needed to perform the installation. Before installing the appliance, in order not to damage the appliance itself, the metal grease filter should be removed.
  • Page 9: Recirculation Mode

    tubes (Fig. 7.4 & Fig. 7.5) from above the two structures by making them come down to the appropriate hoodseat. Lift the hood together with the structure and the extension tubes to make the four springs (Fig. 7.6) hook to the slots (Fig. 7.3-C).
  • Page 10 Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 11 Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 12 Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 13: Remote Control

    REMOTE CONTROL Remote control used for the remote operation of Caple island hoods: Technical Data Alkaline battery powered : 12 V mod. 23 A Operating frequency : 433.92 Mhz Combinations : 32.768 Max. consumption : 25 mA Operating temperature: -20 ÷ + 55 °C...
  • Page 14: Operation Mode

    OPERATION MODE Standard configuration: Standard configuration requires all “cooker hoods radio control system” to be provided with the same transmission code. In the event two cooker hoods radio control system are installed in the same room or nearby, each system may affect the operation of the another.
  • Page 15 Reset of the Factory configuration: To restore the Factory configuration, follow the procedure described below: press simultaneously buttons for 2 seconds. When Leds light on, press buttons (within 5 seconds). Leds flashing 6 times indicate the procedure is completed. WARNING: This operation deletes permanently the preset codes.
  • Page 16: Timing

    TIMING - As a result of the new EU65 “Energy label” and EU66 “ Ecodesign” regulations issued by the European Commission, which came into force as from January 1st, 2015 , our products have been adapted to comply with these new requirements. All of the models complying with the energy label requirements, are equipped with new electronics including a timer device for speed controls, when the air capacity exceeds 650m³/h.Internal motor models, with maximum air capacity...
  • Page 17: Maintenance

    The charcoal filter should be replaced after every 6 months. however this can depend on its use. replacement filters can be purchased via our Caple website www.caple.co.uk - To clean the appliance itself tepid water and neutral detergent are recommended, while abrasive products should be avoided.
  • Page 18 Notes: Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 19 Notes: Please keep this instruction manual for future reference Instruction manual Oi363...
  • Page 20 Caple Service Fourth Way Avonmouth Bristol BS11 8DW t: 0117 938 7420 e: service@caple.co.uk www.caple.co.uk Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk...

Table of Contents