Makita JR103D Instruction Manual page 6

Switch action
CAUTION: Before installing the battery car-
tridge into the tool, always check to see that the
switch lever/trigger actuates properly and returns
to the "OFF" position when released.
2
1. Lock-off button 2. Lock-off lever
4. Switch trigger
To prevent the switch lever/trigger from accidentally
pulled, the lock-off lever/button are provided.
To start the tool, pull either switch lever or trigger.
• For the switch lever, pull the lock-off lever and
then pull the switch lever to start the tool.
• For the switch trigger, depress the lock-off button
and then pull the switch trigger to start to the tool.
The lock-off button can be pressed from either
right or left.
The tool speed is increased by increasing pressure on
the switch lever/trigger. Release the switch lever/trigger
to stop.
NOTICE: Do not pull the switch lever/trigger hard
without pulling the lock-off lever/button. This can
cause switch breakage.
Lighting up the front lamp
CAUTION: Do not look in the light or see the
source of light directly.
1
1. Lamp
Pull the switch lever/trigger to light up the lamp. The
lamp keeps on lighting while the switch lever/trigger is
being pulled.
The lamp goes out approximately 10 seconds after
6 ENGLISH
1
4
3
3. Switch lever
releasing the switch lever/trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Adjusting the shoe
2
1
1. Hex wrench 2. Hex bolt
along its cutting edge, reposition the shoe to utilize a
sharp, unused portion of its cutting edge. This will help
to lengthen the life of the blade.
To reposition the shoe, loosen the bolt with hex wrench.
Slide the shoe to the desired position and then tighten
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the recipro/jig
saw blade
CAUTION: Always clean out all chips or foreign
matter adhering to the blade, blade clamp and/or
slider.
For Model JR103D
1
1. Recipro saw blade
3. Loosen
2
2. Blade clamp sleeve
3
-