Before Your First Use - Wolfgang Puck BRCCM1000 Use And Care Manual

Before Your First Use

Carefully unpack your Brewer and all parts and place on a stable, level
surface. In order to ensure that your Brewer works perfectly it was tested
with water before leaving the factory. You may find a little water remaining in
the machine, or notice condensation in the Water Reservoir. This is normal.
Before you use your Brewer for the first time, perform an initial cleansing
brew by running water through the brew cycle without using a capsule in
the Brewer. We recommend cleaning your Brewer according to the care and
cleaning section of this manual.
During shipping in colder climates, your Brewer could be exposed to
temperatures below freezing. We recommend that you allow your Brewer to
remain at room temperature for at least 2 hours after unpacking.
Programming the Cup Size Buttons
Your Brewer can be programmed to brew 5 different sizes, 4oz, 6oz, 8oz,
10oz and 12oz. You will notice that the control panel has only 3 cup sizes,
however the brew size can be programmed in groups of 3 sizes: 4oz 6oz 8oz,
or 6oz 8oz 10oz, or 8oz 10oz and 12oz. The factory default is 8oz 10oz and
12oz. To change the grouping follow the instructions below:
1 Ensure that the Brewer is unplugged before
programming.
2 Press the Small Cup Button and hold it down
while simultaneously plugging the Brewer
into the outlet until you hear two short beeps.
The On/Off Button will begin to blink and the
Large Cup Button will illuminate steadily which
represents the default setting of Group three:
8oz – 10oz – 12oz.
3 Press the Medium Cup Button to change the
setting to 6oz – 8oz – 10oz.
4 Press the Small Cup Button to change the
setting to 4oz – 6oz – 8oz.
5 After you have selected your preferred size
press the On/Off Button to record the setting
to the Brewer memory.
6 Press the On/Off Button again to turn your
Brewer back on using your new settings.
7
The new settings will stay in memory even if
the Brewer is unplugged.
Group Button
1 Small
2 Medium
3 Large
Small
Cup
Medium
Cup
Large
Cup
On/Off
4oz 6oz 8oz
6oz 8oz 10oz
8oz 10oz 12oz
8
Programming the Auto-Off Setting
The Brewer will shut off automatically once the auto shut-off time is reached.
The default setting from the factory is 1 hour. To change the auto shut-off
time follow the instructions below:
1 Ensure that the Brewer is unplugged before programming.
2 Press the Medium Cup Button and hold it down while simultaneously
plugging the Brewer into the outlet until you hear two short beeps.
The On/Off Button will begin to blink and the Medium Cup Button will
illuminate steadily which represents the default auto-off setting of 1 hour.
3 Press the Small Cup Button to change the setting to fifteen minutes
4 Press the Large Cup Button to change the setting to two hours.
5
After you have selected the preferred auto-off time press the On/Off
Button to record the setting to the Brewer memory.
6 Press the On/Off Button again to turn your Brewer back on using your
new settings.
7 The new settings will stay in memory even if the machine is unplugged.
Reset Brewer to Factory Defaults
1 Ensure that the Brewer is unplugged before resetting.
2 Press the Large Cup Button and hold it down while simultaneously
plugging the Brewer into the outlet.
3 The buttons will flash twice indicating that the Brewer has been
successfully reset to the factory defaults of brew size group three
(8oz - 10oz - 12oz) and the auto-shutoff time of 1 hour.
9