Advertisement
1. Description
This accessory tool connects an emulation pod and the target. It can be mounted on the same
foot pattern as the MCU housed in the 80-pin 0.65mm pitch QFP. It is applicable to the M16C and 740 Family, etc.
2. Package Components
(1) DIRECT80S main unit (16.8x16.8mm)
(2) DIRECT80S User's Manual (this manual)
3. Specifications
Table 1 Specifications
Item
Package
Max. current
Insertion/removal
iterations of connector
Insulation resistance
4. Application
(see Figure 2)
Mount this dummy IC on the foot pattern on the target.
Then connect the emulation pod at the top of dummy IC.
Before using M3T-DIRECT80S, be sure to read the
precautions on page 3.
5. Target Foot Pattern
Figure 3 shows the recommended foot pattern of M3T-DIRECT80S.
Note: The recommended foot pattern of M3T-DIRECT80S is a common foot pattern for 80P6
S-A and M3T-DIRECT80S. For DUMMY80S, use the foot pattern recommended by
Matsushita Electric Works, Ltd. shown in the DUMMY80S User's Manual.
Figure 3 Recommended foot pattern of M3T-DIRECT80S
(see Figure 1)
Description
PRQP0080JA-A (formerly: 80P6S-A)
(80-pin 0.65mm-pitch QFP)
200mA, 5V
20 times guaranteed
100MΩ or over
0.65±0.05
0.35±0.05
12.35
14.6
Min. 17.5
Figure 1 Package components of M3T-DIRECT80S
: position of No 1 pin
Be sure to match the position of
No. 1 pin of the foot pattern and
each part.
Figure 2 Usage of M3T-DIRECT80S
(2/4)
M3T-DIRECT80S main unit
Emulator
M3T-DIRECT80S
Advertisement
