Getting ready
The receive operation is performed only while
the watch is in the Timekeeping Mode (normal
timekeeping).
Normally the mode hand points to the
●
current day of the week.
Navigating Between Modes
l
1.
Move to a location appropriate for signal
reception and orient the watch so its
display is pointed straight up at the sky.
2.
Hold down (B) for at least three seconds.
Release the button as soon as the second
hand points to "T+P".
The second hand will move in the
●
following sequence: "Y(YES)" or
"N(NO)" n "T (TIME)" n "T+P".
This indicates that position information
●
acquisition has started.
Second hand
If position information acquisition is
●
successful, the second hand will move
to "Y(YES)" and then the watch will
automatically adjust its time and day
settings.
If position information acquisition fails
●
for some reason, the second hand will
move to "N(NO)" and then the watch will
indicate the current time and day
without adjusting them.
Operation Guide 5412
Note
Reception takes anywhere from
●
about 30 seconds to about two
minutes.
It can take as long as 13 minutes
●
when leap second information is
included.
You may experience location
●
information acquisition problems
Mode
hand
when you are in the vicinity of a time
zone borderline.
The watch's time and day will not be
indicated correctly if the Home City
(Time Zone) setting is not right for
your location. Perform position
information acquisition in a
representative city in your time zone
or in a location that is well within the
time zone. Or you can perform a time
information receive operation to
adjust time and day settings after
configuring Home City (Time Zone)
and summer time settings manually.
Selecting a Time Zone
l
Acquiring GPS Time Information
l
Manually
Acquiring GPS Time Information
Manually
You can use a button operation on the watch
to receive GPS signal time information. When
the receive operation is successful, the
watch's Home City (time zone), day, and time
settings will be adjusted accordingly.
Note
GPS signal reception requires large
●
amounts of power. Perform it only
when necessary.
Getting ready
The receive operation is performed only while
the watch is in the Timekeeping Mode (normal
timekeeping).
Normally the mode hand points to the
●
current day of the week.
Navigating Between Modes
l
1.
Move to a location appropriate for signal
reception and orient the watch so its
display is pointed straight up at the sky.
2.
Hold down (B) for at least one second.
Release the button as soon as the second
hand points to "T (TIME)".
The second hand will move in the
●
following sequence: "Y(YES)" or
"N(NO)" n "T(TIME)".
This indicates that time information
●
receipt has started.
Second hand
If information acquisition is successful,
●
the second hand will move to "Y(YES)",
and then the watch will automatically
adjust its time and day settings.
If reception fails for some reason, the
●
second hand will move to "N(NO)" and
then the watch will indicate the current
time and day without adjusting them.
Note
Reception takes anywhere from
●
about seven seconds to about one
minute.
It can take as long as 13 minutes
●
when leap second information is
included.
Mode
hand
4