Removing The Sata 3.0 M.2 Cards - Cisco UCS B200 M5 Installation And Service Note

Removing the SATA 3.0 M.2 Cards

Procedure
Step 1 Align the two holes on the module with the holder pins.
Step 2 Push the module into the holder on both ends, making sure the holder clips snap in. Push on the four corners
of the module to fully install it. Avoid touching board components.
Figure 8: Installing the Mini-Storage Module
Note
Removing the SATA 3.0 M.2 Cards
This task describes how to remove the SATA 3.0 M.2 cards from the M.2 mini-storage module.
Cisco UCS B200 M5 Blade Server Installation and Service Note
26
Note the orientation of the SD cards. They should be inserted with the label facing
up.
Servicing a Blade Server