Cleaning Schedule [To Be Performed By Store Personnel] - Oasis CO34R Installation And Operating Manual

CLEANING SCHEDULE [TO BE PERFORMED BY STORE PERSONNEL]

AREA FREQUENCY
Case Daily
Exterior
Daily
Daily
Weekly
Monthly
Case Daily
Interior
Daily
Weekly
Weekly
Weekly
Acrylic: Clean acrylic sneeze guard with a mild soap and water solution and a soft cloth.
Caution! Never use ammonia-based cleaners on acrylic. Incorrect cleaning agents
or abrasive cleaning cloths cause acrylic surfaces to 'cloud' over time.
Stainless Steel "Mirrors" on Each Inside End Panel:
 Wash with a solution of hand dishwashing liquid detergent and water; or a solution of
baking soda and water. Rinse and polish dry with paper towel or soft cloth.
 Never use scouring powders or steel wool. It will scratch stainless steel.
 Brighten by polishing with cloth dipped in vinegar or in ammonia; sprinkle baking soda
on sponge and rub gently; rinse. Polish dry with paper towel.
 Remove streaks or heat stains by rubbing with club soda.
End Panels, Front Panel, Toe-Kick, etc.: Wipe off all surfaces with warm water and mild
soap solution and non-abrasive cloth.
Wood, Laminate and Painted Surfaces: Clean with mild soap and water solution and a
soft cloth.
Under Case: Remove rear panel (and/or front panel). Clean under case with vacuum.
Decks & Inserts: Wipe down and clean with mild soap, water & soft cloth.
Shelves: Shelves can be cleaned with a warm soap and water solution and soft cloth or
paper towel. For stubborn stains or residue, shelves can be removed and cleaned with
soap and water solution or submersed in hot, soapy water solution. Rinse thoroughly.
Dry. Return to case.
Decks & Inserts: Remove and clean with mild soap, water & soft cloth
Shelving Brackets / Air Return Grilles / Decking

Wipe off shelving brackets, air return grilles and decking with moist cloth.

Shelving brackets can be removed for more thorough cleaning.

Air return grilles can be removed for more thorough cleaning.

Decking is NOT to be removed by store personnel.
Condenser Coil: Vacuum or brush grille condenser coil at case front. Use metal or fiber
brush to remove dust and dirt that can collect on condenser coils. Be careful not to
damage the fins on the coil.
INSTRUCTIONS
15