Installing A Power Supply - HP Omen X Hardware Reference Manual

Installing a power supply

The computer supports power supplies that follow the ATX standard with a maximum of 1450 W.
CAUTION:
maximum rating of the computer power supply.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the system board tray
4. Use the security tool from the tool kit
cover, located on the rear of the case.
CAUTION:
image.
5. Install the power supply bracket onto the power supply.
6. Route the power cables into the case, and then insert the power supply (1).
28 Chapter 2 Hardware upgrades
To prevent damage, the overall power consumption of the computer must not exceed the
(Removing and replacing the access panel on page
(Installing a system board on page
To avoid damaging the cover, pry only on the side of the cover as shown in the following
(Preparing for disassembly on page
(Accessing the tool kit on page
8).
18).
25).
9) to remove the power supply