The power consumption data in the table and the other information given in the
Product Data Sheet (Enclosure A to this manual) are defined in relation to EU
Directives 812/2013 and 814/2013.
Products equipped with regulator knobs have the thermostat positioned in the setting
condition at its set <ready to use> position shown in the Data Sheet (Enclosure A),
used by the manufacturer to declare the appliance's energy class.
This appliance is conforming with the international electrical safety standards
IEC 60335-1 and IEC 60335-2-21.
The CE marking of the appliances attests its conformity to the following EC
Directives, of which it satisfies the essential requisites:
- LVD Low Voltage Directive: EN 60335-1, EN 60335-2-21, EN 60529, EN 62233,
EN 50106.
- EMC Electro-Magnetic Compatibility: EN 55014-1, EN 55014-2, EN 61000-3-2,
EN 61000-3-3.
- RoHS2 Risk of Hazardous Substances: EN 50581.
- ErP Energy related Products: EN 50440.
User Instructions
PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE
The heater is insulated to a high standard therefore it may be left on all the time. The
temperature of the water may be adjusted by turning the knob on the front of the
heater, allow half an hour for the temperature to stabilise between settings. The
maximum temperature setting is achieved with the knob turned fully clockwise to the
MAX position this will give a water temperature of approximately 65-68˚C. In hard
water areas we recommend a maximum of 60˚C which corresponds to a knob
position of approx. 11.00 o'clock. The minimum setting offers frost protection. The
neon light shows when the heating element is working, under control of the
thermostat. If in doubt ring Applied Energy Products Service Dept. on 0844 372 7766.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
Water Regulations
These regulations ensure a good supply of wholesome water, and that only
approved materials, pipes and fittings are used to convey water.
9
Need help?
Do you have a question about the MW10 and is the answer not in the manual?
Questions and answers