andrews WHiX49 Installation Manual page 19

Installation
1. Attach the mounting bracket to the wall.
The parts to be used vary depending on
the attachment method.
* Never use electric drivers, impact drivers and so forth.
Tightening with excessive force may result in
deformation of the mounting bracket and/or failures.
<When attaching to a junction box>
• Use the raised countersunk head screws to
attach the mounting bracket to the junction box.
(In this case, the wall anchor and round
countersunk head wood screws are not used.)
Junction box
Top
Bottom
Confirm the orientation of the
mounting bracket is correct.
<When attaching to a wood surface>
• Use the raised countersunk head wood screws
to attach the mounting bracket.
(In this case, the wall anchor and raised
countersunk head screws are not used.)
Top
Confirm the
orientation of the Bottom
mounting bracket.
<When attaching to a concrete wall surface>
• Drill a φ6mm hole, approx. 25mm~30mm
in depth, and hammer in the wall anchor.
Attach the mounting bracket using the raised
countersunk head wood screws.
(In this case, raised countersunk head screws
are not used.)
Wall anchor (accessory part)
Top
Confirm the orientation
Bottom
of the mounting bracket.
2. Remove the decorative frame from
the remote controller.
(The remote controller is inserted in
Remove the remote
controller while pulling
the decorative frame
forward.
Mounting bracket
3. Connect a Y-shaped terminal of the remote
(accessory part)
control cord to a terminal stand of the
remote control in back side.
Push down only section A (
Raised countersunk
insulated cover (clear) to the front, and
head screw
(accessory part)
attach Y-shaped terminal from an insulated
cover (clear) top side.
Mounting bracket
(accessory part)
Raised countersunk
head wood screw
(accessory part)
Remote controller cords
(Be careful about the
installation direction of
the Y-shaped terminal.)
For exposed wiring, use
scissors or shears to
carefully cut "the wires inlet tab"
of the decorative frame to create
slot for wires before attaching to
wall mount.
Mounting bracket
(accessory part)
Wires inlet tab
Raised countersunk
head wood screw
* If the Y-shaped terminal is not covered, the
(accessory part)
exposed section may come into contact with the
mounting bracket resulting in improper operation
or failure.
the decorative frame.)
* Do not remove the insulating cover (clear).
* Be careful about the installation direction
of the Y-shaped terminal.
* * Do use an electric driver, the impact
screwdriver absolutely.
The position of a terminal stand changes with
kinds of remote control.
THIS SIDE UP
* Check the terminal is
covered with Section A
(
cover (clear, see Fig. 1).
Decorative frame
Main remote
controller body
Decorative frame
) of an
) of the insulating
17