andrews WHiX49 Installation Manual page 18

Post-installation Checks
(1) Check if the remote controller is installed securely.
(2) Verify remote controller operation (see OPERATING
INSTRUCTIONS).
* Press the Power On/Off button approximately 5 seconds
after connecting power to the system.
* Check if the temperature setting on the remote controller
is appropriate.
Included Parts List
Remote Controller
Confirmation before the setting
■ Introduction
• Make sure that the power is not turned on (the breaker is "OFF" or the power plug of equipment
is disconnected).
• Check the included parts list.
■ Confirmation before the setting
• Choose a place that is easy to use in consultation with our customers (It is necessary to get the
approval of the visitor).
• Do not be attached to the following place;
1. The place where the temperature becomes higher (near a gas stove)
2. The place where direct rays hit (near a window etc.)
3. The place which requires steam (near a gas stove and a rice cooker etc.)
4. The place which requires a spray (near a hot water tap etc.)
5. The place which requires oil (near a gas stove)
6.The place which uses chemical specialities (Benzine, Oils and fats system detergent etc.)
■ Confirmation of the remote-control cord
The remote controller cord can be extened up to 100m.Please use the thing of required length
according to the conditions of the spot.
By splicing the cord and using 18 gauge wire to extend the cord to
the appropriate length.For using it, please be sure to attach Y-shaped
terminal with a resin sleeve.
Be careful for a mustache not to come out.
When a mustache comes out, please be sure to reattach Y-shaped terminal.
A mustache contacts other parts and causes failure of apparatus.
16
(The value in ( ) indicates the quantity.)
Mounting
Raised countersunk
bracket
head wood screw
(1)
(1)
Explanation to the Customer
Explain the "Important Safety
Information", "Operation Procedures"
and "Follow-up Service" according
to the Owner's Guide supplied
with the water heater.
Raised countersunk
Wall anchor
head screw
(2)
(2)
(For junction box
installation)
Machine
screw
(2)
(2)
Y-shaped terminal
with a resin sleeve
mustache