andrews WHiX49 Installation Manual page 16

Connecting Quick Connect Cord-2
For Quick Connect Multi System Installation use part Quick Connect Cord-2 only. (sold separately).
Caution
The wire coloring on the Quick Connect Cord-2 will
not be the same as the wire coloring of the
connection plug inside the unit.
* The remote controller can be connected to
either unit A or B. Do not connect a remote
controller to both units.
* Disconnect the remote controller from either
unit A or B prior to installing the Quick Connect
Cord-2.
Connecting the Quick Connect Cord-2 to the two units.
1. Turn off the power.
2. Remove the front cover of the heater (4 screws).
3. Pass the Quick Connect Cord-2 through the wiring
throughway and into the unit.
4. Plug the connector on the Quick Connect Cord-2
to the receptacle inside the unit.
5. Attach the ground wire of the Quick Connect Cord-2
to the terminal block fi xing plate.
(If the ground wire is not attached, electrical noise
may cause problems).
6. Secure the Quick Connect Cord-2 with a clamp.
7. Replace the front cover.
14
1.Red 1.Red
2.Black 2.Black
3.White 3.White
4.Green 4.Green
5.Blue 5.Blue
6.Blue 6.Blue
A
Quick Connect
Cord-2
Clamp
Connector
Wiring Throughway
1.White 1.Red
2.Green 2.Black
3.Red 3.White
4.Black 4.Green
5.Blue 5.Blue
6.Blue 6.Blue
B
"Quick Connect Cord-2" tag
Ground wire Connector
(Use one of the vacant holes)
Coupling Cord