Remington 498 Operating Instructions Manual page 19

Tool Disassembly and
Assembly
6. Remove piston assembly from piston sleeve (see Figure 4).
Piston Sleeve
Piston
Figure 4 - Removing Piston From Piston Sleeve
7. Tilt rear of base plate down. Guide will slide out.
B. REMOVING RUBBER PAD
1. Loosen screw on back of rubber pad with 5mm Allen wrench.
2. Detach rubber pad from top of tool first, then pull entire rubber pad from tool.
Rubber Pad
5mm Allen Wrench
Figure 5 - Removing Rubber Pad
C. REMOVING ROCKER ARM
Rocker arm assembly is located on rubber pad.
1. Push out rocker arm pin (see Figure 6).
2. Remove rocker arm and spring from rubber pad.
Rubber Pad
Rocker Arm
Rocker Arm Pin
Spring
Figure 6 - Removing Rocker Arm
19
114915