Remington 498 Operating Instructions Manual page 11

6. Power fasteners are a permanently installed fixture. An act of demolition is
required for their removal. Appropriate safety precautions must be taken.
Shank
Plastic Flute
7. NEVER use common nails or other materials as fasteners. Remington
Fasteners are manufactured from special steel and heat treated to produce a
very hard, yet ductile, fastener.
8. NEVER pry a power load out of the strip. Prying can discharge the load causing
serious injury (See Troubleshooting Guide, pages 23 and 24). NEVER attempt
to reload used strips.
UNLOAD
2
9. If work is interrupted for any reason, ALWAYS remove the power load strip
before removing the power fastener.
114915
Safety Precautions
Head
1
11
Power
®