Disassembly and Reassembly
5.19 Regi Roller
1. Before you remove the Regi Roller, you should
remove:
- HVPS (Refer to 5.14)
- LIU Unit (Refer to 5.15)
- Shield Main Lower(with Main PBA) (Refer to 5.16)
- Main Drive Ass'y (Refer to 5.17)
2. First remove the Plan Washer securing the Regi
Clutch and then pull the Regi Clutch, as shown below.
3. Remove the E-ring below the both side of the Regi
Roller, as shown below.
E-ring
Regi Roller
Service Manual
5-26
4. Take off the Sheet and then remove the Regi Pulley,
Regi Pulley
Clutch
5. To remove the Regi Roller, first slide the left side to
Plain Washer
E-ring
Regi Roller
Notice : Do not grab the rubber part of the Regi Roller, it
as shown below.
Sheet
right side and then take out the left side, as shown
below.
Regi Roller
2
Paper Guide
may cause a malfunction due to a foreigen
object.
Bush
1
Samsung Electronics