Power Switch; Operator Panel - Samsung CLX-3160FN Service Manual

System Overview

3.4.8 Power Switch

The Switch is located at rear-side of printer and must be marked to indicate on and off.

3.4.9 Operator Panel

(1) Configuration
Operations Panel uses Main Control and separated OPE Chip Micom and work as inner program,
systemic operation is serial system which exchange Date with SIO Port of Main Control. OPE Panel is approximately
composed of Micom part, Matrix part and LCD.
(2) Micom controller
Micom has ROM, RAM, I/O Port built-in and displays and lights LCD by CPU command of Main Control Part and report
Key recognition Data to Main Control Board.
3.4.10 Sensor
Paper empty (Cassette)
3.4.11 CRUMS
The CLX-3160 Series engine will be equipped with electronics that can read and write data into NVRAMs otherwise
known as CRUMs that reside within 1) C, M, Y, K Toner cartridges and 2) Imaging kit(Developer, OPC, ITB). The CRUM
has a company ID, and Samsunga electronics logo.
The toner CRUM also identifies the type of toner cartridge (Standard or High Capacity). The CRUMs contain fixed data
such as the low warning point, specified life point, and hard stop point (on toner, not on IBT unit) and also store the cur-
rent life count (pages count, pixels count, images count) and % of usage (gas gauge) data.
3.4.12 LOW / OUT Behavior for consumables
The consumable low and out behavior on CLX-3160 Series engine is specified by SEC.
FP Device for life end
message detection
Toner CRUM
Imaging Kit CRUM
Fuser No
T2 Roller No
Pick-up No
Service Manual
3-34
Law(90%) Life(100%)
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
Hard stop Reset to 0
Yes(115%) No
No No
No Yes
No Yes
No No
Samsung Electronics