Audio Settings; General Settings - Primare SC15 User Manual

AUDIo SettInGS

The AUDIo SettInGS menu allows you to customise the
balance and start-up volume, and the maximum and mute
volume.
AUDIO SETTINGS
BALANCE
STARTUP VOLUME
MAXIMUM VOLUME
BAlAnCe
Allows you to adjust the balance between 00LR-9 (far left),
00LR00 (centred, default) and -9LR00 (far right).
StARtUP VolUMe
Sets the general startup volume to between 0 and 60. The
default is 0.
MAXIMUM VolUMe
Set maximum volume limit between 0 and 99. The default
is 99.
MUte VolUMe
Sets the volume when unit is muted. You can choose
between 0 (default) and 0.
If the current volume is lower than the specified MUte
VolUMe, the volume will be set to 0 when pressing mute.
SC15 Prisma System Control Center User Guide

GeneRAl SettInGS

The GeneRAl SettInGS menu allows you to configure the
general operation of the SC15:
GENERAL SETTINGS
FRONT PANEL
0
AUTO-DIM
00LR00
STANDBY SETTINGS
0
99
SHoW InPUtS
Choose between All (default), to show all inputs, or WItH
SIGnAl, to show only inputs that have a signal.
FRont PAnel
Choose loCKeD to lock the front panel buttons, or
UnloCKeD (default) to use them.
To unlock the front panel buttons use the remote control to
select this menu, or remove power from the SC15 for a
few seconds.
AUto-DIM
Allows you to choose the delay for dimming the display
after no user interaction, between: AFteR 1MIn, AFteR
5MIn, AFteR 10MIn (default), or oFF.
StAnDBy SettInGS
Displays the StAnDBy SettInGS menu to allow you to
specify the standby settings.
StAnDBy MoDe can be set to eCo to reduce the standby
consumption to less than 0.5W, but only allows the SC15
to wake from the analogue and digital inputs, or noRMAl
which also allows the SC15 to wake from streaming and
the PC/MAC input.
AUto-StAnDBy automatically switches the SC15 to
standby if there is no user interaction or audio from the
current source for a specified delay: AFteR 10MIn, AFteR
15MIn, AFteR 20MIn (default), or oFF.
note: The AUto-StAnDBy function will be disabled if the
network has not been set up.
FACtoRy ReSet
Resets the SC15 to the factory default settings.
You are prompted to confirm. Select yeS to proceed or
no to cancel.
0
FIRMWARe VeRSIonS
UNLOCKED
AFTER 10MIN Displays the FIRMWARe VeRSIonS menu to allow you to
view the versions of firmware installed.
15