Configuring The Settings; Using The Settings Menus; Audio Settings; General Settings - Primare NP5 Prisma User Manual

C O NF I G U R I NG T HE SETTINGS

Using the settings menus

You can view and change the NP5 Prisma settings using
the Prisma app. For more information see Download the
Prisma app, page .

audio settings

The audio settings menu allows you to customise the
balance and start-up volume, and the maximum and mute
volume.
output
Specifies whether the output is Variable (default) or Fixed.
Selecting Fixed will show a loud-volume warning. Select
yes to proceed or No to cancel the fixed gain setting.
If Variable is selected the following additional settings are
available.
Balance
Allows you to adjust the balance between 00LR-9 (far left),
00LR00 (centred, default) and -9LR00 (far right).
startup volume
Sets the general startup volume to between 0 and 60. The
default is 0.
maximum volume
Sets the maximum volume limit between 0 and 99. The
default is 99.
mute volume
Sets the volume when unit is muted. You can choose
between 0 (default) and 0.
If the current volume is lower than the specified mute
volume, the volume will be set to 0 when pressing mute.
Digital output
Allows you to adjust the output sample rate between ,
96, and 19kHz.
1

General settings

The General settings menu allows you to configure the
general operation of the NP5 Prisma:
standby settings
Displays the standby settings menu to allow you to specify
the standby settings.
auto-standby automatically switches the NP5 Prisma to
standby if there is no user interaction or audio from the
current source for a specified delay: after 10min, after
15min, after 20min (default), or off.
Note: The auto-standby function will be disabled if the
network has not been set up.
rs232 link
The rs232 link submenu lets you customize your RS
link settings. For information about setting up a link see
RS232 Link setup, page 15.
Baud rate specifies the speed the RS commands are
being sent: 4800 or 115200.
linked volume settings specifies the volume settings that
will be used in the app for the NP5 Prisma when linked to
a Primare device.
auto-on turns on linked device when starting the NP5
Prisma.
auto-off sets the linked device to standby when the NP5
Prisma goes into standby.
Connect to device. Pressing Connect sends out a command
that forces the linked device to answer. If the NP5 Prisma
receives an answer link status will show Connected.
Factory reset
Resets the NP5 Prisma to the factory default settings.
You are prompted to confirm. Select yes to proceed or No
to cancel.
You can also perform a factory reset by pressing and
holding the reset button on the rear panel for 6 seconds.
All LEDs will begin to flash red to warn you. Factory reset
is in progress while all  LED are RED. Do not remove
power during this process.
NP5 Prisma Network Player User Guide