Enttec Datagate Mk2 Quick Start Manual page 7

Web: RDM Sensors (License required)
RDM Sensors page, allows discovering all RDM devices
and monitoring all sensors supported by the RDM devices
found. Examples include: Temperature, Current and,
Voltage sensors. The displayed sensors values are
refreshed, automatically every few seconds.
Values can be exported, or emailed at intervals set using
the settings page. Sensors layout can be saved and
loaded, to minimize any delay in discovering them again
and again.Firmware Update
You can update the firmware on the Datagate Mk2, via the
web browser. Get the new firmware files (they are
available on website:
Download them to your desktop and then follow
instructions in the Datagate Mk2's web browser page,
under the Settings section.
Note: While the firmware is being updated, please do not
power off the unit, please wait until the web-page is
processing. (up-to 5 minutes)
If the web-page does not refresh automatically, please
open the home page on the browser manually, and verify
that the update has succeeded.
7
www.enttec.com/datagate).
NMU
NMU (Node Management Utility) is a free Windows and OSX
application that is used to manage compatible ENTTEC DMX
over
NMU will not directly allow you to configure the Datagate
Mk2 itself, but it can help you find your unit's IP address and
then open a browser window to make the required changes.
To employ the NMU, follow this set of instructions:
•
Please download and install the application from
www.enttec.com/nmu
•
Ensure that your Datagate Mk2 is hooked up
physically by Ethernet cable to the same physical
network as the computer on which you will run the
NMU.
•
Start the application.
•
Press the Discovery button.
•
Select Datagate Mk2.
•
An IP Address will be shown next to any Datagate
Mk2 which are located.
Connector pin out
5pin DMX OUT/ DMX IN:
Pin 1: Ground
•
Pin 2: Data -
•
Pin 3: Data +
•
Pin 4: NC
•
Pin 5: NC
•
Quick Start Manual
Datagate MK2 70044
For latest version visit:
www.enttec.com
Ethernet
RS232:
Pin 2: TX
•
Pin 3: RX
•
Pin 5: Ground
•
nodes.
ID: 2691