Enttec Datagate Mk2 Quick Start Manual page 3

Pressing any of the panel buttons/keys will activate the
next screen on the LCD Menu.
Selection Menu
1-load profile
2-Setup
3-Status
4-Restart
1-Load Profile
Lists all available profiles on the Datagate Mk2, list can
be scrolled using up & down keys. Scrolling indicator is
visible when the list allows scrolling.
Pressing Enter at the selected profile will activate the
profile (some profiles might need a license to activate)
2-Setup
1-Change IP
2-Factory Reset
Setup screen allows changing the IP address of the unit
via "Change IP" or doing Factory Reset.
Change IP
This screen further gives two options DHCP or Static IP.
When Static IP is selected, the screen allows you to
change the IP address using the top and bottom button
to scroll the digits and the menu & enter buttons to select
the segment.
Once you are on the last segment of the IP address,
pressing the Enter button, will activate the IP address. It
will take a few seconds for the change to go through,
please wait 30 seconds, before attempting to try again.
Change IP Address
IP: 192.168.001.003
3
Factory Reset
Activating Factory Reset, leads to a simple prompt
confirming your action. Once confirmed, the Factory Reset
will take a few seconds to run. It will end up deleting all your
user created profiles, as well as any saved settings. Please
use this only when needed, or as directed by ENTTEC
support team.
F-Reset in progress
please wait ...
3-Status
Status Screen, allows the following two options:
1-System
2-Network
Both the Status screens are read-only and provide
information about the system and Networking.
These require no user-input and serve as a way of checking
the performance of the unit.
4-Restart
Restart Screen, when activated, prompts for the user to
confirm the selection.
1-YES
2-NO
Once confirmed, Datagate Mk2 will stop the engine and
restart the system. While rebooting the LCD screen will
change between a couple of screens, and the LCD Main Menu
will only be visible, once the system is fully ready. (usually
takes a minute).
System Restarting
Please wait ...
Quick Start Manual
Datagate MK2 70044
For latest version visit:
www.enttec.com
ID: 2691