Enttec Datagate Mk2 Quick Start Manual page 5

Art-Net Stream:
"Send IP address": is the destination
address used when the stream is sending data only
(Unicast).
ESP Stream
: ENTTEC Show protocol DMX over Ethernet
stream (ESP). IP address is the destination address used
when the stream is sending data only.
Kinet Stream
: For example: You can connect Kinet
Stream to an Art-Net Stream to convert and output as Art-
Net. (Kinet stream is supported as input only)
Streaming ACN
: "IP address" is the destination
address used when the stream is sending data only
(default is disabled = 0.0.0.0)
DMX Generator
: Define your own custom DMX Channel
values and assign the selected ones.
Snapshot feature can be used to capture values from an
input stream. All modifications can be done using the
DMX Grid Page.
5
Merge
: HTP or LTP merge operator, drag as many lines to
the input node as you wish to merge
HTP Merge: Higher Takes Precedence - The biggest
•
DMX value will be output per channel
LTP Merge: Latest Takes Precedence - The latest DMX
•
value will be output per channel
Shifter:
can be used to shift a number of channels to
another spot in the INPUT DMX frame
Channels not defined will be left at 0 value
Example: To Shift 100 channels from 10 to 210:
Setup as "start listening at": 10 and, "start sending at": 210,
"number of channels": 100
Switcher 1-2:
Controllable Switch operator, when the
trigger channel (Switch) is greater than the set value,
OUTPUT B is output, in other cases OUTPUT A is output.
Must have all input sources and output sources connected
Quick Start Manual
Datagate MK2 70044
For latest version visit:
www.enttec.com
ID: 2691