ReSound Phone Clip+ Getting Started

GETTING STARTED (Quick guide)
Phone Clip+
Before you can use your Phone Clip+ it is
necessary to:
A. Charge your Phone Clip+
B. Pair it with your hearing instrument
C. Pair it with your mobile phone
D. Connect it to your mobile phone
Consult your hearing healthcare professional to
determine which, if any, of these procedures may
have already been completed for you.

GETTING STARTED

(Quick Guide)
Phone Clip+
A
CHARGE YOUR PHONE CLIP+
1. Plug one end of the charging cable into the
Phone Clip+
2. Plug the other end of the
charging cable into an
electric wall outlet.
Manufacturer according to FDA: Manufacturer according to
Health Canada:
ReSound North America GN Hearing A/S
8001 Bloomington Freeway Lautrupbjerg 7
Bloomington, MN 55420 DK-2750 Ballerup
1-888-735-4327
Distributor in Canada:
ReSound Canada
303 Supertest Road
Toronto, Ontario
M3J 2M4
1-888-737-6863
3. Charging is complete when the red LED
indicator at the top of the Phone Clip+ turns
green with a red blink every 2 seconds. When
charging for the first time, the Phone Clip+
should be charged
for at least 3 hours,
even if the LED
turns green before 3
hours have elapsed.
B
Pair with your hearing instrument... continued
3. Remove the silver cap from the Phone Clip+.
4. Press the small white pairing button to put the
Phone Clip+ into pairing mode for 20 seconds.
While in pairing mode the LED will blink yellow
every 2 seconds.
PAIR WITH YOUR HEARING
B
INSTRUMENT
1. Turn ON your
Phone Clip+ by
sliding the ON/
OFF switch down
to the ON position.
A white "I" icon will
On
be visible on the
base of the switch and the LED indicator will
now blink green every 2.5 seconds.
2. Open the battery door on your hearing
instruments
5. While in pairing mode, turn on the hearing
instruments by closing the battery doors on
both hearing instruments.
6. A melody of beeps will be heard in both
hearing instruments once they successfully
pair with the Phone Clip+.
Replace the cap on the Phone Clip+ when
pairing is complete.