Schwinn MPower Echelon2 Owner's Manual page 8

CONSOLE INSTALLATION
If you are upgrading to the Echelon2 from a previous version of console, refer to the Schwinn
MPower Echelon2 Installation. This page does not apply if using 4iiii power input, please refer to the
4iiii installation Instructions on our support site at https://support.corehandf.com/620-8543
You may download the latest version of the Installation Guide, as well as view instructional videos,
by visiting the Schwinn Equipment Support website at https://support.corehandf.com/Echelon2
If you are purchasing new bikes with consoles pre-installed, you may refer to the Installation Guide
for setup instructions, or refer to the "Service Menu Navigation and Operation" section of this guide
for descriptions of and instructions for each of the console settings, and how to calibrate the power
sensor and check power sensor calibration.
NOTE: Each Echelon2 power sensor kit comes with a small, red, plastic calibration tool that
resembles a Lego® toy:
Calibration Tool
It is very important to keep these tools, because the power sensor cannot be calibrated with-
out it. If you are purchasing bikes with the consoles pre-installed, then the installer is required to
leave the tools with you. If not, please contact the dealer/installer responsible for installing the con-
soles and request these tools. You may also contact Schwinn Support to request calibration tools.
Go to support.schwinnequipment.com for contact details.
Page 8