NETGEAR GS728TPv2 Hardware Installation Manual page 6

24-Port and 48-Port Gigabit PoE+ Smart Managed Pro Switches with 4 SFP Ports
• Includes 19-inch rack-mount kit for rack installation.
• Full compatibility with IEEE standards:
- IEEE 802.3 Ethernet
- IEEE 802.3i 10BASE-T
- IEEE 802.3u 100BASE-T
- IEEE 802.3ab 1000BASE-T
- IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX
- IEEE 802.1Q VLAN tagging
- IEEE 802.3x Full-duplex flow control
- IEEE 802.3ad Link aggregation (LAG with LACP)
- IEEE 802.1ab LLDP
- IEEE 802.1p Class of Service (QoS)
- IEEE 802.1D Spanning Tree Protocol (STP)
- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP)
- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
- IEEE 802.1x RADIUS network access control
- IEEE 802.3az Energy Efficient Ethernet (EEE)
- IEEE 802.3af Power over Ethernet (PoE)
- IEEE 802.3at Power over Ethernet plus (PoE+)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information table. The table contains
up to 16K Media Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs.
• NETGEAR green power-saving features:
- Energy efficiency mode that fully conforms to the IEEE802.3az standard
- Per-port automatic change to a lower power mode when the port link is down
Introduction
6