Dynojet Power Commander V Installation Instructions Manual page 4

FIG.D
FIG.E
FIG.F
16-067 www.powercommander.com
8 Plug the PCV wiring harness in-line of the stock wiring harness and ignition
coils (Fig. D).
The pair of PCV coil leads with GREEN colored wires will go in-line with the
#1 (left ) coil.
The pair of PCV coil leads with BLUE colored wires will go in-line with the #2
coil.
The pair of PCV injector leads with RED colored wires will go in-line with the
12v side of either coil. This is designated by the BLACK marking on the stock
coil.
9 Plug the PCV wiring harness in-line of the stock wiring harness and fuel
injectors (Fig. E).
The pair of PCV leads with ORANGE colored wires will go in-line with the #1
(left) injector.
The pair of PCV leads with YELLOW colored wires will go in-line with the #2
injector.
10 Unplug the stock wiring harness from the Throttle
Position Sensor.
This connection is on the left side of the throttle bodies.
11 Use the supplied Posi-tap to attach the GREY wire of
the PCV to the RED/YELLOW wire of the stock TPS
connector (Fig. F).
12 Plug the stock connector back on to the TPS.
2016-2017 Honda CB500/CBR500R - PCV F/I - 4