Sharp MX-M266N Manual page 28

FIRMWARE & PRINT DRIVER REVISION
43
Fuser Setting & Adjustment
20 Fuser temperature. correction for low
temperature & humidity (Sim43-1)
22 Fuser temperature. correction for low
temperature & humidity (Sim43-3)
44 Process Control Data
1 Process control mode setting
9 Process control operation 1 data display
14 Temp.& humidity output data
43 DV unit identification information display
46 Copy & Image Density Adjustment
2 B/W copy density adjustment
4 Colour scanner density adjustment
5 B/W scanner density adjustment
8 Colour scanner balance adjustment RGB
9 SPF exposure adjustment
19 B/W auto exposure mode setup
30 Resolution adjust (sub-scan – copy mode)
32 Document background density adjust.
37 B/W image create adjustment
39 Fax Image send sharpness adjustment
40 Fax mode exposure adjust (All modes)
41 Fax mode exposure adjust (Normal)
42 Fax mode exposure adjust (Fine Text)
43 Fax mode exposure adjust (Super Fine)
44 Fax mode exposure adjust (Ultra Fine)
45 Fax mode exposure adjustment (600dpi)
47 JPEG compression rate setting
60 Sharpness adjustment (colour auto mode)
61 Area separation recognition setting
62 ACS operating condition setting
63 Copy low density adjustment
48 Magnification & Motor Adjustment
1 Magnification ratio adjustment (Main & Sub
scan)
5 Magnification ratio adjustment (Sub scan
only)
49 Firmware Upgrade
1 Firmware Upgrade Program
3 E Manual Update Program (Japan)
5 Watermark Update Program
28
50
Image Position Adjustment
1 Lead edge/copy position adjustment
5 Printer lead edge adjustment (sub scan)
6 SPF Lead edge/copy position adjustment
7 SPF Lead edge/copy adjustment value
10 Print off-centre deviation adjustment.
12 Original centre deviation adjustment.
27 Image loss adjustment (Fax/Scanner)
28 Service adjustment (OC/SPF position)
51
Resist Roller Adjustment
1 Transfer current ON timing adjustment
2 Resist roller adjustment
9 Separation voltage ON/OFF timing
adjustment
53
Document Feeder Adjustment
6 SPF document tray size adjustment
7 SPF document tray size adjustment value
set.
8 SPF scanning position adjustment
9 SPF dirt detection setting
10 SPF dirt detection execution
55 MFP Data Setting
1 Engine soft switch setting
2 Scanner soft switch setting
3 Controller soft switch setting:-
SW1-5 Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW3-6 Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7 HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW6-1 Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2 Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3 Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4 Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW9-5 Maintenance notification setting
by Printer MIB:-
0 = Enabled, 1 = Disabled
SHARP