Rack Mounting Smart-1 50/150; Safety Instructions; Determining Space And Weight Requirements - Check Point Smart-1 50 Getting Started Manual

Chapter 2

Rack Mounting Smart-1 50/150

These instructions show how to install Smart-1 50 and 150 in a standard 19 inch rack.
In This Chapter
Safety Instructions
Determining Space and Weight Requirements
Rack Mounting Hardware and Tools
Disconnecting the Appliance Rail from the Mounting Bracket
Attaching the Appliance Rails to the Appliance
Attaching the Appliance Handles or Bracket Ears (Optional)
Attaching the Mounting Brackets to the Rack
Installing Smart 1 50/150 In the Rack

Safety Instructions

Before installing your appliance in a rack cabinet, review the following guidelines:

Make sure that the room air temperature is below 35°C (95°F).

Do not block any air vents. Normally, 15 cm (6 in.) of air space in the
rear and 5 cm (2 in.) in the front provides proper airflow.

Install the appliances in the cabinet starting at the bottom and going up.

Install the heaviest appliance at the bottom of the rack cabinet.

Do not extend more than one device out of the rack cabinet at the same
time.

Connect the server to a properly grounded outlet.

Do not overload the power outlet when installing multiple devices in the
rack cabinet.
Determining Space and Weight
Requirements
Allow sufficient vertical space in the rack for the appliance:
Model Height
Smart-1 50 2U (3.5 inch , 88.9 mm)
Smart-1 150 3U (5.25 inch, 133.3 mm)
Weight (Kg)
28
38
12
12
13
14
15
15
16
17
Page 12