Table of Contents
Advertisement
CT-CCV6X Intel Atom D2000/N2000 COM Express Type 6 Module
Signal
USB_6_7_OC#
4.6.1
USB 3.0
There are four USB 3.0 ports by extended from the Port 3 of the PCIe x1
interface.
Signal
USB_SSRX[0:3]+
USB_SSRX[0:3]-
USB_SSTX[0:3]+
USB_SSTX[0:3]-
4.7
SATA
The PCH NM10 provides two Serial ATA (SATA) ports. The Port 0 and 1
support SATA 3.0 Gb/s device transfers. This interface may be used for Serial
Attached SCSI (SAS).
Signal
SATA0_TX+
SATA0_TX-
SATA0_RX+
SATA0_RX-
SATA1_TX+
SATA1_TX-
SATA1_RX+
SATA1_RX-
(S)ATA_ACT#
The SATA Port 0 of CT-CCV6X can be used for general SATA devices. The
SATA Port 1 of CT-CCV6X has been used for onboard 16GB SSD. Also, this
interface has been reserved on the COM Express connector Row B. When the
onboard SSD of CT-CCV6X is not applied, the interface on the COM Express
connector could be used for general SATA devices.
I/O
Description
USB over-current sense, USB 6 and 7. A pull-up
I
for this line shall be present on the Module. An
open drain driver from a USB current monitor on
the Carrier Board may drive this line low. Do not
pull this line high on the Carrier Board.
I/O
Description
USB differential pairs, channels 0 through 3,
I
receive Data/Address/Command signals
USB differential pairs, channels 0 through 3,
I
transmit Data/Address/Command signals
I/O
Description
Serial ATA 0 transmit differential pair
O
Serial ATA 0 receive differential pair
I
Serial ATA 1 transmit differential pair
O
(reserved)
Serial ATA 1 receives differential pair
I
(reserved)
ATA (parallel and serial) activity indicator, active
OC
low
２６
Advertisement
Table of Contents
