The Interface Commands; Asi Interface Commands; Rs530 + 1*Hssi Interface - Advantech AMT-73 Installation And Operation Manual

Command

The Interface Commands

6.1.7
6.1.7.1

ASI Interface Commands

The ASI interface is fitted on all AMT70 modem on the demodulator card. The TDATA / RDATA
commands control the data rate for this interface.
6.1.7.2

RS530 + 1*HSSI interface

The commands associated with the RS530+HSSI interface card are as follows:
Figure
Interface
Commands
ifmode
iftxclock
ifttinv
iftdinv
ifrxclk
ifrtedgeinv
iftdinv
ifbufmode
ifbufsize
ifbufmon
ifbufreset
ifloopmode
On this interface the data rate are set by the TDATA / RDATA commands.
For more details about all these commands refer to the sections 6 at page 51.
AMT-70/AMT-73/AMT-75 Installation and Operation
Description
Reboot the modem; The option "m' reset the management card and "ALL
reset all the modem cards. After a software upgrade always used the
option ALL.
42: RS530 + 1*HSSI Commands Summary
The modem supports two interface modes; RS485 or single HSSI.
For modems equipped with the router option, an extra mode is supported:
ETHERNET
Set the interface transmit clock mode.
The selections are; INTERNAL | EXTERNAL | RXLOOP | RS530TFD.
Control the edge of data interface transmit clock signal that registers the data (TT).
This signal can be inverted for compatibility with some OEM equipments;
ON | OFF.
Control the TX data inversion; ON | OFF.
Control the selection of RX data receive clock; LOCAL, DTE_TT or DEMOD
Control the transmit clock inversion mode; ON | OFF
Control the RX data inversion; ON | OFF
Control the Doppler buffer algorithm; in AUTO mode the buffer size is controlled
by internal algorithms. In MANUAL mode the buffer can be set statically.
Set the buffer size when the buffer mode MANUAL is selected.
Display the current Doppler buffer usage.
Reset (realign) the receive Doppler buffer on the card
Set the data interface loopback mode.
The selections are;
LINELOCAL, LINEFAR, SYSTEMLOCAL, SYSTEMFAR
102