Getting The Chassis Configuration And Status; The Monitor And Control Commands; Figure 41: Monitor Commands - Advantech AMT-73 Installation And Operation Manual

Demodulator
Specifics
Status information

Getting the Chassis Configuration and Status

6.1.5
Commands that are not specific to the Transmitter (modulator) or Receiver (demodulator) can be
executed from the serial port on the rear panel. These commands are summarized in the following
sections .

The Monitor and Control Commands

6.1.6
The generic commands related to the chassis, front and back panel control are listed below.
Command
General Commands
help
showcfg
default
model
serial
AMT-70/AMT-73/AMT-75 Installation and Operation
rstatus
or
rstatus details
Figure 4 1 : Monitor Commands Summary
Description
Displays an alphabetical list of commands.
Parameters are ;
"??" for the summary
"all" for the list of commands
Display the complete modem configuration installed.
Sets the modem to default configuration values.
Displays the modem model.
Displays the serial number of the modem chassis.
Get internal demodulator status
information.
The command rstatus with no parameters
return the "hex"" status of the peripheral
card.
# rstatus
rstatus = 0x6004
#
the command "rstatus details" return
the decoded status of the card;
# rstatus details
Detailled RX Status (6000):
Timing lock = OFF
Reed Solomon / Viterbi = OFF
Digital AGC Lock = OFF
Carrier Recovery Lock = OFF
Deframing Lock = OFF
External Coding Lock = OFF
Signal Above Limit = NO
Signal Below Limit = YES
Firmware State = RUNNING
ALL lock state = NO
#
100