Cisco UCS C480 M5 Installation And Service Manual page 144

Installing the SUSE Linux Enterprise Server Driver
Step 4
Launch a Virtual KVM console window and click the Virtual Media tab.
a) Click Add Image and browse to select your remote RHEL installation ISO file.
b) Click Add Image again and browse to select your
c) Check the check boxes in the Mapped column for the media that you just added, then wait for mapping to complete.
Step 5 Power-cycle the target server.
Step 6
Press F6 when you see the F6 prompt during bootup. The Boot Menu window opens.
Step 7 On the Boot Manager window, select the physical disk or virtual disk and press Enter.
The RHEL installation begins when the image is booted.
Step 8
Enter one of the following commands at the boot prompt:
• For RHEL 6.x (32- and 64-bit), enter:
linux dd blacklist=isci blacklist=ahci nodmraid noprobe=<atadrive number>
• For RHEL 7.x (32- and 64-bit), enter:
linux dd modprobe.blacklist=ahci nodmraid
The noprobe values depend on the number of drives. For example, to install RHEL 6.5 on a RAID 5
Note
configuration with three drives, enter:
Linux dd blacklist=isci blacklist=ahci nodmraid noprobe=ata1 noprobe=ata2
Step 9
Press Enter.
The prompt asks whether you have a driver disk.
Step 10 Use the arrow key to choose Yes, and then press Enter.
Step 11
Choose fd0 to indicate that you have a disk with the driver on it.
Step 12
Do one of the following actions:
• f you prepared the
press Enter.
• If you mapped the
The installer locates and loads the driver for your device. The following message appears:
Loading megasr driver...
Step 13
Follow the RHEL installation procedure to complete the installation.
Step 14 Reboot the target server.
Installing the SUSE Linux Enterprise Server Driver
For the specific supported OS versions, see the
release.
This topic describes the fresh installation of the SLES driver on systems that have the embedded MegaRAID
stack.
Cisco UCS C480 M5 Server Installation and Service Guide
142
file on a physical thumb drive, insert the thumb drive to the target server and then
dud.img
(or .iso) file as a virtual disk, choose the location of the virtual disk.
dud.img
(or .iso) file.
dud.img
Hardware and Software Compatibility Matrix
Storage Controller Considerations
for your server