Table of Contents
Advertisement
8. Operation
OP1
OP2
OP3
OP4
(5)
(6)
(4)
16
(1)
(2)
(3)
(1)
(2)
(3)
(7)
The RedMax stick edgers are designed for edging
lawn in gardens, parks, roadsides and so on.
Before starting the engine, take the operating
position and adjust the handle position and the
wheel height as necessary.
■ ADJUSTING WHEEL HEIGHT
1. Loosen the wing nut and change the wheel
height to obtain desired cutting depth. (OP1)
(1) Deep cut
(2) Shallow cut
(3) Wing nut
2. After adjusting the height, tighten the wing nut
securely.
Tightening Torque: 51~68in-lbs (6~8N.m.)
WARNING
• Never adjust wheel height with the engine
running.
■ STARTING ENGINE
WARNING
The cutting head will start rotating upon the
engine starts.
1. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
2. Push the primer pump several times until
overflown fuel flows out in the clear tube. (OP2)
3. Move the choke lever to the closed position.
(OP3)
4. Set the ignition switch to the "start" position.
While pulling the throttle lever, push the set
button, and release the throttle, then the throttle
lever is in to the "start" position. (OP4)
5. While holding the unit firmly, pull out the starter
rope quickly until engine fires. (OP5)
(1) choke lever (2) close (3) open
(4) ignition switch (5) start (6) stop
(7) throttle set button
Advertisement
Table of Contents
